1. Turn off heater completely and unscrew gas regulator in the cylinder housing from tank.
- - - - - - - - - - - - - - - - - - - - - - - - - -
2. Remove regulator from gas hose.
- - - - - - - - - - - - - - - - - - - - - - - - - -
3. Remove the Gas tank from the housing.
- - - - - - - - - - - - - - - - - - - - - - - - - -
4. Tilt the unit onto it's side on a chair so the head assembly is more easily accessible.
- - - - - - - - - - - - - - - - - - - - - - - - - -
5. Unscrew three (3) wing nuts from top of reflector and lift reflector off of studs.
- - - - - - - - - - - - - - - - - - - - - - - - - -
6. Unscrew and remove studs from head assembly.
- - - - - - - - - - - - - - - - - - - - - - - - - -
7. Remove 4 screws at base of head assembly being cautious that the weight of head unit does not cause it to fall.
- - - - - - - - - - - - - - - - - - - - - - - - - -
8. Slowly lift head assembly up and out of post.
- - - - - - - - - - - - - - - - - - - - - - - - - -
9. Pull the gas hose out through pole assembly.
- - - - - - - - - - - - - - - - - - - - - - - - - -
10. Place old head assembly and hose aside and this completes the removal process.
- - - - - - - - - - - - - - - - - - - - - - - - - -
11. Place new hose inside post feeding it through as new and snugly fit new Head Assembly to post.
- - - - - - - - - - - - - - - - - - - - - - - - - -
12. Control knob should be above the decal on the post.
- - - - - - - - - - - - - - - - - - - - - - - - - -
13. Attach head assembly to the post and loosely install 4 stability screws.
- - - - - - - - - - - - - - - - - - - - - - - - - -
14. Tighten the screws securely.
- - - - - - - - - - - - - - - - - - - - - - - - - -
15. Insert and tighten 3 studs onto top of head assembly.
- - - - - - - - - - - - - - - - - - - - - - - - - -
16. Place reflector on top of head assembly with studs through the reflector.
- - - - - - - - - - - - - - - - - - - - - - - - - -
17. Fasten the 3 wing nuts securely to the reflector.
• Shipping Weight: 10.00 lbs.